Anna Sentina Using the CUBE KIT you can change the CUBE-10GX presets on the CLEAN, CRUNCH and LEAD channels. 10 amp types are available such as combo amp or stack amp and also specific models for acoustics and bass guitars too.
![]()
How to use CUBE KIT
1. [CUBE KIT] Choose your favorite amp.
Choose your favorite amp with "<" and ">" buttons.
After you've selected the amp, tap the LOAD button.
2. [CUBE-10GX] Select the amp type of CUBE-10GX that you would like to change.
Select the amp type of CUBE-10GX that you would like to change.
Push and hold the "AMP TYPE" button of CUBE-10GX for 2 seconds.
The CUBE-10GX will shift to standby mode and the "AMP TYPE" LED will blink.
3. Connect mobile device and CUBE-10GX.
Connect your mobile device and CUBE-10GX.
Use the lead convertor plug as shown.
Maximize the volume of your device.
(Be sure to lower the volume after use.)
Following the prompts on the display, you can now replace your amp types.
When the replacement has been successfully completed, the "AMP TYPE" LED turns on.
* The "AMP TYPE" LED will blink if the transfer failed. In this case, please just try again.
*You may be able to use other cables/adaptors as shown in this figure, however we cannot guarantee it will be effective.
Setting Application
You can change guide display setting from the setup screen.
(If you select "Off", the prompts will be skipped.)
*The product names mentioned in here are registered trademarks or trademarks of their respective owners. These names are used because it is the most practical way of describing the sounds that are simulated using COSM technology.
How to use CUBE KIT
1. [CUBE KIT] Choose your favorite amp.
Choose your favorite amp with "<" and ">" buttons.
After you've selected the amp, tap the LOAD button.
2. [CUBE-10GX] Select the amp type of CUBE-10GX that you would like to change.
Select the amp type of CUBE-10GX that you would like to change.
Push and hold the "AMP TYPE" button of CUBE-10GX for 2 seconds.
The CUBE-10GX will shift to standby mode and the "AMP TYPE" LED will blink.
3. Connect mobile device and CUBE-10GX.
Connect your mobile device and CUBE-10GX.
Use the lead convertor plug as shown.
Maximize the volume of your device.
(Be sure to lower the volume after use.)
Following the prompts on the display, you can now replace your amp types.
When the replacement has been successfully completed, the "AMP TYPE" LED turns on.
* The "AMP TYPE" LED will blink if the transfer failed. In this case, please just try again.
*You may be able to use other cables/adaptors as shown in this figure, however we cannot guarantee it will be effective.
Setting Application
You can change guide display setting from the setup screen.
(If you select "Off", the prompts will be skipped.)
*The product names mentioned in here are registered trademarks or trademarks of their respective owners. These names are used because it is the most practical way of describing the sounds that are simulated using COSM technology.